Keysight Technologies InfiniiMax III Series, User Manual

Page: 55 / 128

55
2. InfiniiMax III Probe Heads
N5441A InfiniiMax III Solder-in Probe Head
Replacing Wires on the
N5441A Solder-in Probe
Head
The N5441A solder-in probe head’s tip wires can be replaced when they
are worn out or damaged. 0.005” and 0.007” wire kits are included with
each probe head. 0.005” wire can be used for attaching to small vias.
To replace wires, complete the following steps:
1
Begin by clamping the probe head GENTLY.
Figure 37 Clamping the Probe Head
2
Remove the old wires with tweezers while reflowing the solder from
the probe underside.
C A U T I O N Apply heat quickly to avoid damaging your probe.
Figure 38 Removing the Old Wire
3
If necessary, add a small amount of solder to the holes and apply flux.