Keysight Technologies FieldFox A Series, User Manual

Page: 184 / 756

184 Keysight N9927-90001 User’s Guide
SA (Spectrum Analyzer) Mode
SA Mode Settings
— Then All Alignment [Auto] (to enable or disable the All Alignment) –
Default is Auto.
— or
— Then
Align All Now (to manually perform an Align All Now.) This performs
an alignment on all three individual alignments: Amptd Align Now, Burst
Align Now, and ChanEq Now). Refer to “Individual Alignments” on
page 184 .
— Press Enter
If you want to disable the All Alignment [Auto], you can do so in the FieldFox
preferences (i.e., you may want to do this, for example, if you are analyzing the
amplitude stability of a signal).
Refer to the
SA Individual Alignment Control setting in “Preferences” on
page 637 , in Chapter 29 System Settings. See also, “Individual Alignments” .
Individual Alignments
IMPORTANT! It is recommended that you use All Alignment [Auto] or Align
All Now in lieu of the individual alignments ( Amptd Align Now , Burst
Align Now , and ChanEQ Align Now ), because All Alignment [Auto] and
Align All Now includes the individual alignment InstAlign Amptd Align
Now , Burst Align Now , and ChanEQ Align Now . But, if you would prefer to
have manual control over the individual alignments, then refer to the SA
Individual Alignment Control setting in “Preferences” on page 637 , in
Chapter 29 System Settings.
The Individual Alignment softkey is only available, when the preference
SA
-
Individual
Alignment Control
is set to
On
in the FieldFox Preferences menu. Refer to
“Preferences” on page 637
, in
Chapter 29
System Settings.