70
Chapter 6
Reading Out Measured Result
Reading Out Measured Result
Reading out measured result using
This command actually performs two tasks: it triggers the instrument and returns the
results. It is useful, for example, when you want to retrieve measurement results
immediately after triggering the instrument from an external controller.
The readout procedure using the
command is described below.
Step 1.
Use the
:TRIGger[:SEQ1]:SOURce command on page 299
to set up the trigger mode
to the BUS trigger (BUS).
Step 2.
Execute the
Step 3.
Read out the measured result. To repeat the measurement, repeat Steps 2 and 3.
Sample Program
and
to view an example of reading out measured result in
ASCII and Binary format respectively using *TRG command.
