Keysight Technologies B2900 Series, User Manual

Page: 177 / 234

Keysight B2900 User’s Guide, Edition 5 5-23
Front Panel Operations
To Execute Measurement
To Set Measurement Mode
1. For the Single view, press the Measure assist key. For the Dual view, press the
Ch1 Measure or Ch2 Measure assist key.
2. Press AMPS (I) for the current measurement, VOLTS (V) for the voltage
measurement, OHMS (R) for the resistance measurement, or WATTS (P) for the
power measurement.
To Perform Spot Measurement
1. Set the measurement mode (see “To Set Measurement Mode” on page 5-23 ).
2. Set the output voltage or current (see “To Apply DC Voltage/Current” on page
5-13 ).
3. Press the On/Off switch for channel 1 or 2 (Ch1 or Ch2).
The channel starts the specified voltage/current output. While the switch is
turned green, the channel continues the output and changes the value
immediately if it is changed.
4. Press the Trigger key.
The spot measurement is performed.
NOTE To change the Limit value, see “To Set Limit (Compliance) Value” on page 5-13 .
To Stop Measurement
1. Press the On/Off switch for channel 1 or 2 (Ch1 or Ch2) to turn the switch off.
The channel stops source output and measurement.
To Set Measurement Time
For details on this function, see “Measurement Time” on page 6-5 and “Speed” on
page 4-11 .
1. Press the View key to display the Single view.
2. Press the Speed assist key.
3. Press the AUTO, SHORT, MEDIUM, NORMAL, LONG, or MANUAL assist
key to set the measurement time.