Keysight Technologies B1505A, Configuration Manual

Page: 124 / 298

3-18 Keysight B1505A Configuration and Connection Guide
N1265A Connection Guide
Output Connection
HC/MC/DHCSMU via SMU 3 terminals should be connected as follows.
• SMU 3 High Force and Sense to DUT high
• SMU 3 Low Force and Sense to DUT low
• GNDU Force and Sense to DUT low
The GNDU signals will appear at the Selector Output Low terminals as shown in
Table 3-7 .
3. Set the DUT on the socket.
4. Close the fixture cover and perform measurement.
Universal Socket Module (N1265A-011)
This is a blank module, kind of a do-it-yourself kit for supporting variety of packaged
devices. This module can be used by mounting your desired socket or packaged device and
making connections same as the N1265A-010 Inline Package Socket Module.
To use this module, see the following simple instruction. For the component locations and
dimensions, see
Figure 3-8 . Also see "Inline Package Socket module (N1265A-010)" on
page 3-17 to perform measurement.
Figure 3-8 Universal Socket Module
1. Prepare the following parts.
• blank board suitable for mounting the socket or packaged device
• screw M3, 4 ea., for fixing the blank board on the socket module
• wire, adequate length and quantity, for making connections
• hexlobe (torx type) screwdriver T-10
• socket, if you use, and packaged device under test (DUT)
2. Cut the blank board in 90 mm

81 mm square.
3. Make four screw holes on the board. The holes should be 6 mm inside from the edge.
4. Fix the board to the blank module.
5. Remove the cover bottom of the blank module.
165 mm
165 mm
129 mm
160 mm
2
1
3
4
5
6
7
8
Collector / Drain
Emier / Source Base / Gate
N1265A Opt 011
Force Sense
Force Sense Force Sense
Universal Socket Module
1 2
5 6
4 3
91 mm (Nut pitch: 78 mm)
(Nut pitch: 69 mm)
82 mm