STATus Subsystem
Status register programming lets you determine the operating condition of the instrument at any time.
The instrument has three groups of status registers; Operation, Questionable, and Standard Event.
The Operation and Questionable status groups each consist of the Condition, Enable, and Event
registers as well as NTR and PTR filters.
The Status subsystem is also programmed using Common commands. Common commands control
additional status functions such as the Service Request Enable and the Status Byte registers. Refer to
for more information.
STATus:OPERation[:EVENt]
Queries the
for the
group. This is a read-only register, which stores
(latches) all events that are passed by the Operation NTR and/or PTR filter. Reading the Operation
Status Event register clears it.
Parameter
Typical Return
(none)
<
bit value
>
Read the operation status event register: STAT:OPER?
The value returned is the binary-weighted sum of all bits set in the register.For example, with bit 3
(value 8) and bit 5 (value 32) set (and corresponding bits enabled), the query r40.
does not affect this register unless the reset causes an event that the filters are configured to
capture.
STATus:OPERation:CONDition?
Queries the operation condition register. This is a read-only register, which holds the instrument's live
(unlatched) operational status. Reading the Operation Status Condition register does not clear it.
Parameter
Typical Return
(none)
<
bit value
>
Read the operation status condition register: STAT:OPER:COND?
The value returned is the binary-weighted sum of all bits set in the register.For example, with bit 3
(value 8) and bit 5 (value 32) set (and corresponding bits enabled), the query r40.
The condition register bits reflect the current condition. If a condition goes away, the corresponding bit
is cleared.
A
clears this register, other than those bits where the condition still exists after *RST.
3 SCPI Programming Reference
146
Keysight AC6800B Series Operating and Service Guide
Summary of Contents for AC6801B
