Heart Rate Mode
12
HEART RATE MONITOR MODE
The treadmill may at any time be used in the Heart Rate Monitor Mode. If the signal from the chest strap
is detected, heart rate BPM will be displayed in the INCLINE window. The incline will only be briefly
displayed if manual or program changes are initiated. The Heart Rate program is designed to keep your
heart at a desired amount of “beats per minute” by automatically adjusting the incline. For example, you
have programmed in a desired heart rate of 125 BPM and your heart rate is only at 110 BPM. If you are
wearing the Heart Rate Transmitter, correctly the incline will automatically increase to intensify the work
load, causing your heart rate to slowly climb to 125 BPM. The treadmill will attempt to maintain your tar-
get heart rate through adjustments to the incline for the remainder of your workout. In the same respect, if
your heart rate is above your programmed amount of BPM’s, the incline will automatically decrease to
lower your heart rate. You may at any time during the Heart Rate Program adjust/override the speed
and/or the incline by simply pressing the correct corresponding button. You may also change your “Target
Heart Rate” at any time by pressing the TARGET UP or TARGET DOWN button.
HEART RATE PROGRAM OPERATION
1. Plug treadmill into a surge protector outlet. Attach the Red Safety Key on to the treadmill console.
2. Stand on the treadmill and straddle belt. Attach safety key clip to your clothes.
3. Press POWER button. Place the Heart Rate Transmitter strap across your chest and connect ends. (Make
sure your skin is moist and the strap is snug for accurate transmission). At this time, if the display is
receiving a signal from the chest strap, the incline window will begin to settle on your current heart rate.
To use HEART RATE program without the chest strap, continuously hold the EKG grips through out the
whole workout program.
4. Press the HEART RATE PROGRAM button to enter the electronics into the Heart Rate Program. The
incline window will momentarily flash ‘125’, which is the default program target heart rate.
5. The WORKOUT TIME window will blink. Use the SPEED + or – arrows to select your workout time.
Press ENTER PROGRAM.
6. The SPEED window will then blink. Use the same + or – arrows to select the speed for your workout.
Press ENTER PROGRAM.
7. The incline window (if receiving your heart rate accurately) will show current BPM, and the small red
light labeled PULSE adjacent to the incline window, will be illuminated. (If the receiver is not receiving an
accurate reading, the incline window will be flashing - - - -).
8. To adjust the pre-set target heart rate press the /TARGET– button then press the ENTER PRO-
GRAM button.
9. Press START/STOP button. Belt will begin to move after 4 seconds. Step on belt slowly after the belt starts
moving.
10.Press START/STOP button. Belt will begin to move after 4 seconds. Step on belt slowly after the belt starts
moving.
11.The small light at the top of the console labeled TARGET will be illuminated if you are at your target. If
you are not, the arrow shaped lights will illuminate and reflect if you are above or below your goal. If you
are not within 25 BPM of your “Target heart rate” the program will not work. DO NOT STOP TO START
OVER. Continue exercising and your heart rate will naturally increase. The program will continually moni-
tor your heart rate and periodically adjust the incline up or down to increase or decrease the resistance
thereby keeping you at your target zone. At the conclusion of the programmed time the TIME window will
flash 00:00 and the CALORIES/DISTANCE window will continue to accumulate values. The treadmill
will continue operation until the START/STOP button or the PAUSE button is pressed. Press the POWER
button to turn off the treadmill.
Summary of Contents for HealthTrainer HT802t
Page 25: ...Exploded View 25 3FV...
