Assembly
Assembly requires the included allen wrench and
your own phillips screwdriver.
Do not plug in the power cord until all assembly
step are completed.
1. With the treadmill deck in the down position,
leave the unit on the original packing material to
assemble all parts.Refer to Figure 1.
6
Figure 1: Deck in down position
Figure 2: Left and Right Upright Installation
Figure 3: Top Rail Grommet Assembly
2. Feed the cable thru the Right Upright until the
connector is exposed.
Install Right Upright to base using 4 Allen Bolts
M8*15mm and Four Arc Washers. Hand tighten all
hardware at this time.
Repeat for Left Upright . Refer to Figure 2.
Note:
Be careful not to pinch the wire harness.
3. Use the drag line to pull Console Wire Harness
thru the top rail as shown in Figure 3. Place the
grommet over the Console Wire Harness and install
the grommet in the top rail.
Note:
Be careful not to pinch the wire harness.
DRAG LINE
GROMMET
