12
PROGRAM MODE
•
Plug into a standard wall outlet (110-Volt AC, 15-amp circuit).
•
ATTACH THE
RED SAFETY KEY TO THE CENTER OF THE CONSOLE
.
•
Stand on the treadmill and straddle belt.
•
Press POWER button. There will be an eight (8) second delay after pressing the POWER button before data can
be entered. The TIME window will flash.
•
There are three (3) pre-set programs on the 850 and 880HR. Both include Fat Burn, Cardio, and Warm Up
programs. The 835HR also includes a Heart Rate Control program (see the program profiles later in this
manual). Select the program by pressing the appropriate button.
•
Press START/STOP button. Belt will begin to move after 4 seconds. Step on belt slowly after the belt starts
moving.
•
Each of the pre-set programs (6) can also be customized. Follow the instructions below for your
particular model.
•
Customizing programs in P1 and P2 Mode:
Each pre-set program can be customized in the P1 or P2 mode.
After making the program selection, the center window will read “OP.” ”OP” refers to “original program” and is
preset. Press the same program button once more, and the center window will read P1. The “P1” mode is now
accessed. You can now program the Time, Speed, and Incline in P1 mode, which will save your entered
information for future use. The time window will blink. Use the SPEED UP or DOWN arrows to select your
workout time, then press the ENTER button located on the left hand side of the console below the program
buttons. The SPEED window will now be flashing. Using the SPEED UP or DOWN arrows, select the speed for
your workout, then press the ENTER button. Now the INCLINE window will be flashing. Use the INCLINE UP or
DOWN arrows to set your workout incline, then press the ENTER button. To start, press the START/STOP
button. To access P2 mode, press the selected program button three times (once for OP, twice for P1, three
times for P2). Follow the above procedure to customize.
•
TO CHANGE A PREVIOUSLY PROGRAMMED P1, P2, or user program:
Once you have programmed the P1
or P2 modes, you will need to use the PAUSE button to change the program you previously entered. For
instance, if P1 in Fat Burn has been programmed, to change to a new setting, press the Fat Burn button twice to
access P1. Then press the PAUSE button to get the TIME window to flash. Follow the directions above to
continue to change the program.
Program and Operating Instructions
