Proximity Card Reader (RS-485)
AC-1100
Technical Reference Manual
Mounting
The AC-1100 proximity card reader can be mounted against most surfaces, including metal.
Two 0.2” diameter-mounting holes are countersunk into the front of the housing.
Screws and wall anchors are provided with the unit.
.98"
4.72
"
3.94
"
1.77"
Card reader dimensions
When mounting the AC-1100 proximity reader, the following procedure is used:
•
Hold the reader in the position where it is to be mounted
•
Mark the positions of the mounting holes on the mounting surface and then remove the
reader
•
Drill holes in the mounting surface using a suitable drill bit of the correct gauge
•
Drill or auger a hole for the cable feed if necessary
•
Feed the cable through the mounting surface to the scanner
•
Set the address and connect the cables, as detailed in the following sections
•
Insert wall anchors into the holes if necessary
•
Align the reader with the holes and fasten the mounting screws
Copyright KeyMatrix Inc.. All rights reserved.
Revision C
[2005-11-04]
p. 8
