16
17
IR Emitter / OUT Pinout
Wire
Signal
Dashed/
Marked
IR Signal
Solid/Black
Ground
RS-232
RS-232 cables are available through Key Digital and other wire suppliers, and can also
be fabricated by skilled technicians.
Model
Wire
DB9 Pin
Signal
KD-3.5FDB96
3.5mm Stereo to Female DB9
(sold separately)
Red
2
TxD
White
3
RxD
Black
5
Ground
Green
N/C
NA
KD-3.5FDB96 with 3.5mm
TRS Connector
KD-3.5FDB96 after
stripping wire
Extending IR and RS-232 Control
IR
➔
Bi-directional IR control extension is supported and may be used simultaneously with
RS-232.
➔
Set the Control Rotary to adjust the IR In mode for IR Sensor (default at Rx unit) or
Serial IR (default at Tx unit)
➔
Tx Unit IR In corresponds with Rx unit IR Out. Tx Unit IR Out corresponds with Rx
unit IR In.
➔
Rx Unit IR In corresponds with Tx unit IR Out. Rx Unit IR Out corresponds with Tx unit
IR In.
➔
Ground pin is shared if using both channels of IR
IR In
»
The IR Sensor receives signals from a 90° angle at up to 30 ft. away.
»
Maximum supported IR burst frequency is 55kHz.
»
Only the included IR sensors are compatible with KD-X444L. Third-party IR
Sensors may not be compatible.
IR Out
»
IR Out driving power: 5V with 32mA minimum current
IR Sensor / IN Pinout
Wire
Signal
Red
5V Power
White
IR Signal
Black
Ground
KD-X444L_Manual.indd 16-17
2/22/18 11:33 AM