5
›
IR Sensor
: Collects line of sight infrared from
remotes without external connecting block
»
Signal is output on Rx unit / presentation
switch’s IR Out port
»
KD-X2x1WDTx / KD-X2x1WVTx is
NOT
controllable via IR
»
IR and RS-232 supported simultaneously
›
IR In
: Connect to the IR In terminals from a control system or
an IR connecting block.
»
Signal is output on Rx unit / presentation switch’s IR Out port
simultaneously as any IR input collected by the IR Sensor
»
KD-X2x1WDTx / KD-X2x1WVTx is
NOT
controllable via IR
»
IR and RS-232 extension not supported simultaneously
›
RS-232 Terminal (rear)
: Connect with control system for
pass-thru of bi-directional RS-232 signals to/from controlled
device.
»
Supports baud rate up to 115,200bps
»
KD-X2x1WDTx / KD-X2x1WVTx is not controllable via RS-232
›
Input Select Button
: Used to toggle between
Display Port / VGA or HDMI source input or to
activate Auto Switch mode
»
Press and hold for 3 seconds to active Auto
switching. Solid illumination of the backlighting
indicates mode has been set
»
HDMI LED (
blue
) active if HDMI is selected
source
»
Display Port / VGA LED (
blue
) active if Display
Port / VGA is selected source
