11
4.3.4 - PAIRING MULTIPLE KEYBOARDS TO A DECODER
After pairing the keyboard T1 with the decoder D1 and defining the number of digits of the codes, it is
possible to add additional keyboards, in this case T2. After wiring the new keyboard, proceed as follows:
Press and hold the P key on keyboard T2 until the colour
turns RED
RED
> 1 s
On the decoder, within 20”, press briefly and release the
button; the green LED remains on for a long time.
GREEN
Wait a few seconds, the keyboard emits three long BEEPS
> 1s x3
On the decoder, the green LED turns off briefly and then
flashes again at a frequency of 1”
GREEN
CODE
DESCRIPTION
00
all disabled
01
relay K1 enabled
02
relay K2 enabled
03
relays K1 and K2 enabled (default)
DESCRIPTION
EXAMPLE COLOUR BEEP
Start the procedure by pressing and holding the
simultaneously keys
and
until the lighting on the
keyboard turns blue
+ 5
sec. max
BLUE
> 1 s
Type the master code
1234
ORANGE
+
> 1s
Type followed by the new four-digit code and the
operating code (see table), conclude by typing
2022
01
YELLOW
> 1s x3
Repeat the previous sequence
2022
01
GREEN
+
> 1s
4.3.1 – CREATE USER CODES AND CHANGE THE OPERATION OF K1 AND K2
4.3.2 - CREATE USER CODE WITH LIMITED ACCESS
In the following example, the user code that will be created can only operate relay K1.
The administrator can limit the number of activations that a user can perform. The number of accesses
that can be assigned ranges from one to nine. At the end of the operations, the code will be deleted.
DESCRIPTION
EXAMPLE COLOUR BEEP
Start the procedure by pressing and holding the
simultaneously keys
and
until the lighting on the
keyboard turns blue
+ 5
sec. max
BLUE
> 1 s
Type the master code
1234
ORANGE
+
> 1s
Type followed by the new four-digit code followed by
and the number of accesses you want to assign
2 0 2 2
3
YELLOW
> 1s x3
Repeat the previous sequence
2 0 2 2
3
GREEN
+
> 1s
4.3.3 – ASSIGN SPECIFIC FUNCTIONS TO RELAYS AND PROPERTIES TO USERS
Each of the two relay outputs can behave as timed (preset 1” ON) or bistable. In timed operation, the
activation time can be varied. In addition, it is possible to determine which output relay(s) each user
can activate (the default is both relays enabled) and whether it is enabled to change its user code. To
configure the specific features, refer to the 580PADW product instructions downloadable from www.
keyautomation.it.
