Key Automation 900EASY, Instructions And Warnings For Installation And Use

Page: 16 / 28

16
EN
4.4 - Error display menu
Code Description
1 Obstacle detected during closing
2 Obstacle detected during opening
3 Faulty encoder
4 No electric power
5 Dead battery
6 Learnt run over maximum limit
7 Learning of weight failure
8 Motor polarity reversed or encoder channels inverted
9 Relative weight over maximum limit
10 Motor voltage is over maximum allowed
11 Power circuit overload protection occurred
12 Error while reading or writing eeprom memory
13 Monitored device 1 test failed command FOTO
14 Monitored device 2 test failed command FOTO
15 Monitored device 1 test failed command FOTO RALL
16 Monitored device 2 test failed command FOTO RALL
17 Monitored device 1 test failed command STOP
18 Monitored device 2 test failed command STOP
 


 
4.5 - Board actions menu
Table of board actions menu items.
Menu Item Description Action Keypad
4.1 - Cyclic Test performs the automatic door cyclic test OFF start (starts the test)
ON stop (stops the test)
4.2 - Default Parameters restores all the board’s default parameters
are you sure you
want to restore the
DEFAULT values?
yes (restores all the
values)
4.3 - Learning
performs the automatic door travel stroke learning proce-
dure
OFF on
ON stop


CURRENT ERRORS
The errors on the board will be displayed in sequence; otherwise,
the screen will show “no errors for display”.
Keypad: To quit the “Current error display” menu and return to
the “Error display menu” press Exit or Es
To confirm press Ok
Errors:Reading error: appears if it is not possible to establish
communication with the board.
Keypad: To quit the “Board actions” menu and return to the
“Main Menu”, press Exit or Esc
To confirm press Ok
ERROR LOG
The error code and its description will be displayed: error no. 1 is
the most recent error.
Keypad: To quit the “Error log” menu and return to the “Error
display menu” press Exit or Es
To scroll through the parameters press or
Errors: Reading error: appears if it is not possible to esta-
blish communication with the board
Errors: Reading error : appears if it is not possible to esta-
blish communication with the board.
Writing error: appears if it is not possible to write a parameter
on the board during performance of a “cyclic test” or a “learning”
procedure.