Page 2 of 10
KewlFlow™ POWER SUPPLY OPTIONS
Option #1 … 12V Connector (included)
Option #2 … Converter for 110VAC
Option #3 … Battery Pack
PRECAUTIONS - Cooler Use
Do not use anything but water (or water with a recommended cleaning agent) and ice (no dry
ice) in the system.
Do not operate dry - extended dry operation may damage the pump and will void the warranty.
Do not put the entire inner container (with pump) into a freezer - the pump can be damaged if
frozen.
Power requirements are 10 to 15 Volts DC, 0.5 Amps maximum.
FILLING
1) Unzip the cooler's outer shell and rotate the top backward.
2) Open the inner container by pushing down on the lid while lifting up and out on all four
locking tabs.
3) Fill with ice to the top of the container if desired.
4) Add at least 16 ounces of water for system circulation.
5) The pump is auto-priming if submerged in at least 2 inches of water.
6) When replacing the lid, ensure that the gasket in the lid is firmly seated along the entire
top edge of the container.
7) Press down on the lid while engaging the four locking tabs.
POWER CONNECTIONS & OPERATION
1) Pull the Power Switch out of the pouch on the back of the
cooler.
2) Connect the white Power Connector into the mating
connector on the External Power Cord that was included with
your cooler.
3) Plug the other end of the External Power Cord into a 12V
accessory power outlet, or a 110VAC to 12VDC adapter.
4) Turn the pump on using the Power Switch.
5) You may see a small stream of water coming from the outlet
“stem” of the pump if the water level is below it. This is a
normal function of the pump’s self-priming feature.
DRAINING WATER BEFORE REFILLING WITH ICE
There is no need to tilt the cooler over to drain out the water. Instead, follow these steps for an
easier way to drain the cooler:
