Troubleshooting.
Troubleshooting.
What do I do if...
My Home Bar does not recognize a Pod?
Tip:
If your Pod is not recognized, open the app for step-by-step help.
If your Home Bar fails to recognize an authentic Drinkworks Pod, open
the Pod door and re-insert the Pod. Make sure the bar code is at a
12 o’clock position and the Pod basket is fully seated. After two failed
attempts to determine the type of Drinkworks Pod, the Home Bar will
enter an override state. The START button will flash blue, red and purple.
Follow the instructions below to make your drink:
1. Open the Pod door by lifting up the handle and remove the Pod.
2. Find the Drinkworks Pod type printed on the Pod label. It will be a capital letter located
in a triangle under “Pod type.”
3. Re-insert the Pod and close the Pod door.
4. The START button will flash blue, red and purple.
5. Press the START button the corresponding number of times for the Pod type: A=1, B=2,
C=3, D=4, E=5, F=6, G=7 . For example, if you have a C type Pod, press START three times.
6. The CO
2
indicator light will flash the same number of times as you pressed the START
button to confirm your Pod letter choice. If this is correct,
press and hold
the START
button until it flashes blue to accept the recipe.
7. Finally, press START one last time to make your drink!
For easy access to the best Home Bar troubleshooting tips, download the
Drinkworks app for your iOS or Android device and enable push notifications. The
app will immediately notify you of an error and guide you through the steps to fix it.
To ensure quality and consistency, look for this mark on your Pod bar code to
confirm it is an authentic Drinkworks Pod.
21
