Kett VZ-330, Operating Manual

Page: 14 / 24

14
1. Inserting the Battery Pack
1
Turn the printer over and open the battery cover as
shown in Figure 1.
2
Connect the battery pack as shown in Figure 2, turn
it so the label is visible, insert it into the printer, and
close the battery cover. Close the battery cover.
2. Removing the Battery Pack
1
Turn the printer over and open the battery cover as
shown in Figure 3.
2
Pull out the battery pack, grab the connector with your
thumb and index finger, and remove it by pulling up on
it. Close the battery cover.
Even if AC adapter is not used, this printer can be
used by the battery pack.
＊
The battery pack has already been installed as for
this printer at purchase. Please charge it before use,
because it is not charged enough.
＊
The battery discharges when it is not used for a long
time, therefore, immediately recharge the battery
after long periods of storage.
＊
Always use an specified battery pack.
＊
A fully charged battery pack can print about 3000
lines.
Connector
Battery pack
Label
Battery pack cover
Figure 1 Figure 2 Figure 3 Figure 4
9. Handling the Battery Pack