K
E
T
T
H
N
2
N
I
B
B
L
E
R
SPECIFICATIONS
MAXIMUM MATERIAL THICKNESS (CUTTING CAPACITY)
MILD STEEL 10 Ga. (.1345 in. / 3,42 mm)
STAINLESS STEEL 12 Ga. (.1046 in. / 2,66 mm)
NON-FERROUS 8 Ga. (.1644 in. / 4,18 mm)
MAXIMUM CUTTING SPEED
90 INCHES PER MINUTE (2.3 meters per minute)
MINIMUM CUTTING RADIUS*
6 inches (152,4 mm)
PHYSICAL SIZE
12-5/8” (321 mm) Long, 4-1/8”(105 mm) wide
HEIGHT
9-3/4” inches (248 mm)
WEIGHT
14 lbs. (6,35 kgs.)
MOTOR
STARTING HOLE SIZE
1 5/8 inches (41,3 mm) in diameter
SIZE OF CUT WIDTH
13/64” (5,16 mm)
IMPORTANT OPERATING HINTS
1. Always disconnect power cord before attempting adjustment or maintenance.
2. Minimize air gap between stripper foot and material by adjusting the stripper position (item 16).
3. Tighten all screws and check punch and die clearance at least once daily.
4. Keep a spare punch and die in stock.
5. Turn nibbler on before engaging material.
6. When possible, spread a thin fi lm of oil on surfaces being cut as this will greatly increase the
life of the punch and die.
7. Stop machine immediately if it should jam. Never force tool. Back out punch by in sering screw
driver in operating slot at rear of motor X and turning motor shaft counter clockwise.
8. Let nibbler do the work as guiding tool is all that is necessary and forcing will only cause it to
operate improperly.
9. Only cut the gauge metal that is recommended or servicing and expensive part damage will
occur.
10. Observe lubrication instructions.
11. Always make frequent checks on motor brushes, replacing if worn.
1 H.P. 110 volts 6 amp
Summary of Contents for HN2
Page 5: ......
