background image

Cleaning and Disinfection

• The lancet is disposable and is intended for single use only.
• The lancing device is reusable.
• We recommend for lancing device cleaning and disinfection, you should use  

 

  Micro-Kill+™ (Micro-Kill Plus™), and please refer to your Owner’s Manual for more    
  information about the cleaning and disinfection procedures with a disinfecting wipe.

• DO NOT rinse the device under water. 
• Do NOT place the device in a dishwasher or use detergents.

Before collecting a drop of blood:

► Wash and dry your hands before you start.
► Select the puncture site at the fingertip.
► Rub the puncture site for about 20 seconds before penetration.
► Clean the site using cotton swab moistened with 70% alcohol and let it air dry.

NOTE

Alternative Site Testing (AST)

7.

 

Lancing the finger

Press the lancing device’s tip firmly 
against the lower side of your fingertip. 
Press the release button to prick your 
finger, then a click indicates that the 
puncture is complete.

8.

 

Remove the device from the puncture 

site. After penetration, remove the first 
drop of blood with a clean cotton swab. 

Gently squeeze the punctured area to 

obtain another drop of blood. Be careful 

NOT to smear the blood sample. Apply the 

blood to the test strip.

10.

 

Slide the ejector forward to remove the 

used lancet. Dispose of the lancet 
according to your local regulations.

 ► For collecting blood samples from 

sites other than the fingertip, use the 

clear cap.

Testing on sites other than the fingertip is referred to as alternative site testing (AST).  
Please read the 

Alternative  Site  Testing

 section in your Owner’s Manual before you 

perform AST. Substitute the lancing device cap with the clear cap for alternative site 
testing. Pull the cocking control back until it clicks. When lancing the forearm, upper arm, 
or hand, avoid lancing the areas with obvious veins in order to prevent excess bleeding.

9.

 

Remove the lancet by twisting the cap 

off first. Safely dispose of the used lancet 
by placing the protective disk on a hard 
surface, and pushing the exposed tip into 
the disk. 

This option is not available for all 
devices. Refer to the 

Intended Use

 in 

your meter’s Owner’s Manual if you can 
perform AST with your device. 

NOTE

1

2

Read instructions before use. 

For assistance outside of these hours, please contact your healthcare professional.

Distributed by 

KETO-CHECK, INC.

952 School St. Suite 212
Napa, CA 94559-2824
Tel: 800.513.1965 10am-4pm PST

Reviews: