0. HANDLING INSTRUCTION
0.1
LIST OF CONTENTS
The Keston C40P,C45 and C55(P) are supplied almost totally pre-assembled. Since the units
use standard 50 mm muPVC pipe for the flue and air intake systems the boiler is packed in a
single box without additional flue kit. All additional components are packed inside the boiler
cabinet itself. The following is a list of components and their location in the boiler cabinet
Equipment List
Item
Quantity
Location
Wall Bracket Rawl Plugs
5
Inside accessories bag
Wall Bracket Wall Fixing Screws
5
Inside accessories bag
Wall Mounting Bracket
1
Secured to inside right hand
side of boiler case
Wall Mounting Bracket Nuts
2
Inside accessories bag.
Wall Mounting Bracket Washers
2+2
Inside accessories bag
Gas Cock (22 mm cxc)
1
Inside accessories bag
50 mm muPVC Air/Flue Terminals
2
Inside accessories bag
Flue Spigot Nipple
1
Inside accessories bag
Cabinet Cable Entry Clamps
2
Inside accessories bag
User Control Knobs
2
Inside accessories bag
Outside Temperature Sensor
1
Inside accessories bag
Document List
Item
Quantity
Location
User Instructions
1
In A4 envelope
Lifting Instructions
1
In A4 envelope
Installer Notice
1
In A4 envelope
Registration of Purchase - 2 YEAR Guarantee
1
In A4 envelope - C45&C40P
2 YEAR Warranty Plan
1
In A4 envelope - C45&C40P
12 Month Guarantee
1
In A4 envelope - C55&C55P
Installation Template
1
In document bag
Remove the cabinet shell by removing the four retaining screws in the top of the cabinet and
the three retaining screws in the bottom of the cabinet.
0.2
Recommended Handling Procedure
Before hanging the appliance on the wall it is best to store the appliance laid on its back with
the casing on. When ready to hang the boiler on the wall remove the casing and place to one
side. At this stage it is assumed that the wall bracket is correctly secured on the wall face.
a)
Have the wall bracket nuts and washers to hand so that they can be accessed whilst
holding the boiler in position on its mounting bracket.
b)
The boiler has a dry weight of 61.5kg (136 lbs) and will therefore require at least two
people to lift without the use of lifting aids.
c)
Lift the boiler by gripping at the four corners of the boiler back plate. When lifting this
appliance the back should be kept straight at all times. Avoid twisting at the waist -
reposition the feet instead. Avoid upper body bending when holding the appliance and
keep the boiler as close to the body as possible.
d)
Lift the boiler and locate onto the two studs of the wall mounting bracket.
e)
Hold the boiler on the wall bracket by applying pressure onto the front surface of the heat
exchanger.
f)
Place the wall mounting bracket washers over the bracket studs protruding through the
back plate of the boiler.
g)
Secure the boiler onto the wall bracket by fixing the wall mounting bracket nuts onto the
wall bracket studs. These should be tightened well.
WD536
The Keston C45, C40P, C55 & C55P
Page : iii