LED Aquarium Lighting
Problem
Light doesn’t
turn ON
Unit is
flickering
Make sure the unit is connected to the power
supply and the power supply is plugged into
an outlet with the correct specifications.
Make sure the power supply has the right
specifications.
Make sure the unit has not overheated by
operating at a room temperature above
100°F/40°C.
Make sure electrical power is available to the
AC outlet being used.
Make sure the power supply has the right
specifications.
Make sure the device is operating within the
specified operating temperature range. If unit
overheats, it will automatically shut down.
Make sure the fan is operating properly.
TROUBLESHOOTING GUIDE
Cause / Solution
Please make sure to perform maintenance before doing any
troubleshooting.
MAINTENANCE
1.Keep the air intake holes (E), venting holes (G), and fan
clear of dust. To clean the fan, unplug the unit and insert
the tip of a CO2 dust blower (or similar dust blower) in one
of the venting holes (G) on the unit's outer shell. Hold and
spray. You can also gently vacuum out the light through
the venting holes.
2.Keep the lens (H) clean. If the lens becomes contaminated
with water, dust, or other particles, unplug the unit and
clean the lens with isopropyl alcohol. Wet a cotton swab or
a napkin in isopropyl alcohol, gently wipe the surface of
the lens, and let it dry.
P/N : 5870027
CONTROLLING MULTIPLE A360 LIGHTS
Multiple A360N and A360W lights can be controlled by either a single
external 0~10V controller or manually.
CABLES
Available cables (each sold separately):
• Control Cable (Please consult www.kessil.com for list of
available cables and compatible controllers)
• Unit Link Cable (6' male/male with 3.5mm stereo plug)
• Control Extension Cable (6' male/female with 3.5mm
stereo plug to 3.5mm stereo jack)
STARTING A CHAIN
Connect two or more lights with the Kessil Unit Link Cable,
as shown above.
CONTROL METHODS
There are two ways to control a chain of lights:
• With an external controller;
• Without external controller (Tuning Controls on first light
control all other lights in chain).
Should a longer cable be needed, the Kessil Control Extension
Cable may be used.
Each light has its own independent power supply. Any number
of lights can be daisy chained together without degradation of
signal. However, in longer chains a slight delay in response
may occur.
Tuning Controls are disabled when device senses input
cable.
Output
Unit Link Cable
Input
To next light
Input from Controller
Spectral Tuning Control
Light Intensity Control
Scan this code on your smart-
phone to learn more about Kessil
Visit Us
Kessil Lighting
A DiCon Brand
1689 Regatta Blvd, Richmond, CA 94804
(510) 620-5250
www.kessil.com
