4.
Ausrichten und Ecken mit Klebe-
streifen markieren. Säule beiseite
stellen und Klebepads anbringen
und Säule damit fixieren.
Adjust the pillar and mark the corners
with an adhesive tape. Remove the pillar
and place the adhesive pads into the
corners of the marked place, then set
the pillar back on the marked place.
182
110
3
2
Montage darf nur an festen Wänden mit
ausreichender Stabilität
erfolgen.
Installation is only recommended to walls
with
sufficient stability.
ACHTUNG: Schrauben und Dübel müssen
nach Wandbeschaffenheit ausgewählt
werden (nicht im Lieferumfang)!
Attention: Choose screws and dowels suitable to the
condition of wall (are not included)
+
-
749012102 0000 Seite 3 von 7
4x
SW4
4.
Werkzeug nicht im Lieferumfang.
Tools are not included.