Kernau KGH 6422 CI X, User Manual

Page: 45 / 95

EN
45
WARNING
Make sure that no additional weight to be applied on the gas hose.
DANGER
Disconnect the product from mains supply before starting maintenance and cleaning
works.
DANGER
Allow the product to cool down before you clean it.Hot surfaces may cause burns!
A BURNER
1 kW
G 30-30
mbar LPG
(0,50 mm)
G20–20
mbar
NATURAL GAS
(0,72 mm)
R BURNER
3 kW
G 30-30
mbar LPG
(0,85 mm)
G20–20
mbar
NATURAL GAS
(1,15 mm)
WOK BURNER
2,5 kW
Ø100
G 30-30
mbar LPG
(0,82 mm)
G20 – 20
mbar
NATURAL GAS
(1,15 mm)
SR BURNER
1.75 kW
G 30-30
mbar LPG
(0,65 mm)
G20–20
mbar
NATURAL GAS
(0,97 mm)
WOK BURNER
3,3 kW
Ø100
G 30-30
mbar LPG
(0,89 mm)
G20 – 20
mbar
NATURAL GAS
(1,28 mm)
WOK BURNER
3,8 kW
Ø126
G 30-30
mbar LPG
(0,98 mm)
G20 – 20
mbar
NATURAL GAS
(1,35 mm)
1. Nitril/rubber Gasket
2. Elbow pipe
3. LPG hose coupler
• Use flat sole pans on the hob. In this manner, thermal energy can be conducted the
most effectively.
• It is recommended not to use concave pans.
• Use pans with proper diameters. Do not use smaller pans than the diameter of the
burner. When small pans are used it may cause pot smoking and reduced efficiency
of the hob.
• Use dry sole pans. Do not place the cover of the pan (especially when wet) on the
burner.
• Use a wet cloth to wipe the hob. However, if it becomes dirty, use water with de -
tergent to ensure drying.
Service life of the product will extend and the possibility of problems will decrease
if the product is cleaned at regular intervals.
Complete the installation by using gasket in the mid -
dle for the LPG hose entrance indicated on the above
figure during the natural gas LPG conversion.