Kernau KDI 4643, User Manual

Page: 37 / 108

EN
37
IMPORTANT:
When a drain hose longer than 4 m is used, the dishes might remain dirty. In
that case, our company will not accept responsibility.
ELECTRICAL CONNECTION
• The earthed plug of your machine should be connected to an earthed outlet supplied by suitable
voltage and current. If there is no earthing installation, have a competent electrician carry out an
earthing installation. In case of usage without earthing installed, our company will not be responsible
for any loss of usage that might occur.
• The plug on this appliance may incorporate 10A fuse depending on the target country.
• Your machine is set according to 220-240 V. If the mains voltage in your location is 110 V, connect
a transformer of 110/220 V and 3000 W inbetween. The machine should not be plugged in during
positioning.
• Always use the coated plug supplied with your machine.
• Running in low voltage will cause a decline in washing quality.
• The machine’s electrical cable should be replaced by an authorised service or an authorised
electrician only. Failure to do so may lead to accidents.
• For safety purposes, always make sure to disconnect the plug when a wash programme is finished.
• In order not to cause an electric shock, do not unplug when your hands are wet.
• When disconnecting your machine from the mains supply, always pull from the plug. Never pull the
cord itself.
WATER OUTLET HOSE
The water drain hose can be connected either directly to the water drain hole
or to the sink outlet spigot. Using a special bent pipe (if available), the water
can be drained directly into the sink via hooking the bent pipe over the edge
of the sink. This connection should be at a minimum of 50 cm and at a
maximum of 110 cm from the floor plane.