Kernau KCH 1461 X, Instructions For The Installation, Maintenance And Use, Page: 30 / 32

EN
30
CHAPTER 5. CLEANING AND MAINTENANCE
MAINTENANCE
Attention! Before performing any maintenance operation, isolate the hood
from the electrical supply by switching off at the connector and removing
the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug
must be removed from the socket.
CLEANING
The cooker hood should be cleaned regularly (at least with the same
frequency with which you carry out maintenance of the fat filters) internally
and externally. Clean using the cloth dampened with neutral liquid detergent.
Do not use abrasive products.
DO NOT USE ALCOHOL!
Warning: Failure to carry out the basic cleaning recommendations
of the cooker hood and replacement of the filters may cause fire risks.
Therefore, we recommend observing these instructions. The manufacturer
declines all responsibility for any damage to the motor or any fire damage
linked to inappropriate maintenance or failure to observe the above safety
recommendations.
GREASE FILTER
Traps cooking grease particles.
This must be cleaned once a month (or when the filter saturation indication
system – if envisaged on the model in possession – indicates this necessity)
using non aggressive detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle. When washed in a dishwasher,
the grease filter may discolour slightly, but this does not affect its filtering
capacity. To remove the grease filter, pull the spring release handle.