TFCD_A-BA-e-2110
23
hi
1. If the weighed portion is above the upper limit value, the
sound is heard and the tolerance symbol
OVER
is
displayed.
2. If the weighed portion is below the upper limit value, the
sound is not heard and the tolerance symbol
UNDER
is
displayed.
low
1. If the weighed portion is below the lower limit value, the
sound is heard and the tolerance symbol
UNDER
is
displayed.
2. If the weighed portion is above the lower limit value, the
sound is not heard and the tolerance symbol
OVER
is
displayed.
3. Confirm the selection by pressing , <
> will be displayed for a while.
The window for value entry in the numerical form will be displayed where you
can enter the lower limit value. The tolerance symbol
will be displayed, the
active item is blinking.
4. Enter the lower limit value (for entering the numerical value see chapter 3.2.1)
and confirm.
5. <
> will be displayed for a while. The window for value entry in the
numerical form will be displayed where you can enter the upper limit value. The
tolerance symbol
will be displayed, the active item is blinking.
6. Enter the upper limit value (for entering the numerical value see chapter 3.2.1)
and confirm.
7. <
> will be displayed for a while, the scale will switch to the weighing mode
again.
Tolerance check start:
Ensure the test weighing mode is active. To do it, press
TARE
and hold it long
enough for <
> to be displayed.
Place the weighed material (< 20
d
) and, based on the tolerance symbols / audible
signal, check if the weighed material belongs to the preset tolerance range.
Weighed material
below
the preset tolerance
Weighed material
in the preset
tolerance range
Weighed material
above
the preset tolerance
•
To cancel the limit values, enter <00000.0 kg>.
•
Deactivate the test weighing mode. To do it, press
TARE
and hold it long
enough for <
> to be displayed.
