DE-BA-defsi-0640
54
7.3 Taring
Switch-on the balance using the
key and wait for the
„0“
display.
Put the tare vessel on the weighing plate and press the
key. The balance
display goes to „
0
“. The weight of the container is now internally saved.
If after finishing the weighing process the
key, is pressed again, „
0
“ appears
anew in the display.
The taring process can be repeated any number of times, e.g. when adding several
components for a mixture (adding).
The limit is reached when the whole weighing range is exhausted.
After removing the taring container the total weight is displayed as negative display.
7.4 PRE-Tare
function
Using this function the weight of a tare vessel can be stored.
This value also remains saved if the balance meanwhile has been switched off and
switched on again.
Switch-on balance using the
key and wait for the „
0
“ display.
Put tare vessel on the weighing plate and press the
key 6 times until „PtArE“
flashes on the display. By actuating the
key, the current weight on the weighing
plate is saved as PRE-Tare weight.
To switch off this function, unload the weighing plate and press the
key 6 times,
until „PtArE“ flashes on the display. Then press the
key. The stored PRE-Tare
weight is deleted.
7.5 Plus/minus
weighings
For example unit weight control, fabrication control etc.
Switch-on the balance using the
key and wait for the
„0“
display.
Put the nominal weight on the weighing plate and tare to „
0
“ using the
key.
Remove the nominal weight.
Put the test objects subsequently on the weighing plate, the respective deviation from
the nominal weight is displayed with the respective sign to „+“ and „-“.
According to the same procedure also packages with the same weight can be
produced, referring to a nominal weight.
Back to weighing mode by pressing the
key.
