KERN Optics OZL 456, User Instructions

Page: 9 / 19

OZL-45R-BA-e-1510 8
4
Assembly
The first step is to position the microscope stand on a firm, level surface .
The holder is firmly attached to the pillar of the stand. You can then fit the
microscope head to the holder, by passing the objective through the holder ring until
the rest of the head is above the ring.
Please see section 5.5 for more details on adjusting the stand.
The head must then be fixed in a suitable position, using the small screw on the right
of the holder ring.
Ideally it is then parallel on the central axis of the stand base
(see figure on page 9).
Now you can
remove the protective caps from the tube connectors so that you
can then fit the eyepieces . When doing this, please be particularly careful that you
do not touch the optical lenses with your fingers and that no dust enters the
apertures.
You should also
never fit two eyepieces with different magnifications .
With regard to the use of
transmitted light illumination you must make sure that
the frosted glass stand inlay is fitted in the centre of the stand base , so that the
transmitted light can be used correctly.
It is always best to
fix the different stand inlays using the adjusting screw on the
front side of the stand base.
When using reflected light please make sure that the
connection cable between the
holder and the objective is plugged in .
Additional optional attachments:

The eye cups supplied with the microscopes can be fitted to the eyepieces.
(see section 5.6)