2-8
MST-MHT SERIES 071320
FIGURE 2-3. INITIAL CHECKOUT SETUP
5.
Set switch S1 (Figure 2-4) to CLOSE SENSE position.
NOTE:
If the sequence in step 4, above, is reversed (i.e., a-c power applied to the Controller
first and MST-MHT power modules last), the operator must send an IEEE 488 Device
Clear command via the Host Computer prior to issuing other commands.
For proper time delays between commands refer to PAR. 3.1.2. For details on the SCPI com-
mands, refer to the Instruction Manual for the applicable controller (see PAR. 1.4.1).
Summary of Contents for MST 100-2MHT
