KEPCO BOP-ME 1KW, Operator'S Manual, Page: 111 / 234

BOP HIPWR 091719
3-35
3.3.10.5 VIEWING STORED WAVEFORMS
After observing the precautions of PAR. 3.3.10.1, press
@
from the power-up screen to access
the Saved Waveforms screen (Figure 3-11). Use
Y
or
U
or the encoder to highlight the name
of a previously saved waveform, then press
!
to view the Waveform Settings screen (see Fig-
ure 3-12). The lower half of the LCD shows a representation of the programmed waveform. The
letters along the vertical axis of the graph at the lower left side indicate whether the waveform is
programmed to operate in voltage or current mode. The message at the upper right indicates
the actual mode of the power supply while the waveform is being executed. The upper half pres-
ents the waveform name, positive and negative protection settings, the repetition count, fol-
lowed by a listing of segments. The type (square, sine, etc.), frequency, p-p amplitude, and
whether the segment is initial (run only the first time) or repeating is indicated by I or R, respec-
tively. To see the offset, start/stop angle, initial/repeat for a segment, use
Y
or
U
or the
encoder to highlight the segment, then press
!
(Initial/Repeat is not available for the last seg-
ment, since the last segment must repeat). Use use
Y
or
U
to highlight the parameter, press
!
, then set the value or highlight the desired setting and press
$
to save for power-up or
%
to abort and exit without changing the parameter.
FIGURE 3-12. EDIT WAVEFORM MENU
3.3.10.6 CREATING A NEW WAVEFORM
1. After observing the precautions of PAR. 3.3.10.1, press
@
from the power-up screen to
enter the Saved Waveforms screen (Figure 3-11), highlight one of the waveforms desig-
nated
Empty , then press
@
. The New Waveform Menu screen (Figure 3-13) opens.
VOLTAGE
SOURCE