Kenyon REVOLUTION, Owner'S Manual

Page: 10 / 20

10
KENYON Max Load Power Supply Plug Type
Part #
B70202 1300 Watts 120V AC 11A 60Hz 3 prong grounded
cord with GFCI
WARNING:
If the electrical supply does not meet the product specifications, consult with a
licensed electrician before proceeding with installation!
Do not remove the GFCI device from the supplied power cord under any circumstance.
Electrical Requirements
Countertop Installation
Your Revolution Grill is supplied with a factory installed polished stainless steel flange that
accepts four oval head wood screws for mounting. The trim flange of the grill is designed to hold
the unit firmly in place in the countertop. If desired, you may seal the edge of the countertop
beneath the trim flange. We recommend a NON-ADHESIVE such as acrylic latex caulk. This will
help reduce the chance of damage to the trim flange should the unit need to be removed from
the countertop. Should you need to remove the unit from the countertop after installation simple
take a piece of fishing line and run back and forth under the trim flange to break the caulk bond.
WARNING:
Allow a 2 inch (2”) minimum clearance between the bottom of the grill and combustible
surface located below, ie: the upper edge of a drawer installed below the grill (Fig. 7, page
12). Failure to provide proper clearances and ventilation may result in a fire hazard.
Check the Electrical Supply Requirements
This product must be installed in accordance with national, state and local electric codes. The
following table provides the correct voltage, amperage and frequency that must be supplied to the
grill.
The supply must be from an individual grounded circuit that is protected by a circuit breaker and
rated per the specifications for the model as shown in the table below.