Kenwood WD-K10PBS, User Manual

Page: 5 / 148

PRECAUTIONS
●
Do not charge the transceiver and battery pack when they are wet.
●
Ensure that there are no metallic items located between the transceiver
and the battery pack.
●
Do not use options not specified by KENWOOD .
●
If the die-cast chassis or other transceiver part is damaged, do not
touch the damaged parts.
●
If a headset or headphone is connected to the transceiver, reduce the
transceiver volume. Pay attention to the volume level when turning the
squelch off.
●
Do not place the microphone cable around your neck while near
machinery that may catch the cable.
●
Do not place the transceiver on unstable surfaces.
●
Ensure that the end of the antenna does not touch your eyes.
●
When the transceiver is used for long transmissions, the radiator and
chassis will become hot. Do not touch these locations when replacing
the battery pack.
●
Always switch the transceiver power off before installing optional
accessories.
●
The charger is the device that disconnects the unit from the AC mains
line. The AC plug should be readily accessible.
WARNING
Turn the transceiver power off in the following locations:
●
Near explosives or blasting sites.
●
In aircrafts. (Any use of the transceiver must follow the instructions
and regulations provided by the airline crew.)
●
Where restrictions or warnings are posted regarding the use of
radio devices, including but not limited to medical facilities.
●
Near persons wearing pacemakers.
●
In explosive atmospheres (inflammable gas, dust particles, metallic
powders, grain powders, etc.).
●
While taking on fuel or while parked at gasoline service stations.
3