OTHER OP-2
KEY BEEP
You can turn the transceiver beep function ON or OFF as
desired.
1
Enter Menu mode and access Menu 000.
2
Turn the beep function ON or OFF.
• Even with the beep function turned OFF, the transceiver
will emit a beep tone under the following conditions:
1) When Auto Power Off is activated, the transceiver will
beep 1 minute before the power turns off.
2) After transmitting for the maximum time duration
according to the Time-out Timer, the transceiver will
beep
■
Beep Volume
Each time you press a key, the beep tone will sound.
If you have left the beep function turned ON, you may
wish to adjust the volume level of the beep.
1
Enter Menu mode and access Menu 001.
2
Set the beep volume to a level from 1 to 7.
• The default is level 5.
EXTERNAL SPEAKER CONFIGURATION
This transceiver has two speaker jacks for external
speakers, as well as an internal speaker. You can enjoy
a variety of speaker configurations by using one or two
external speakers. Received signals on bands A and B
are output depending on how you want the internal and/or
external speakers to function.
1
Enter Menu mode and access Menu 002.
2
Set the speaker mode to MODE 1 or MODE 2.
• Refer to the table below for configurations based on the
mode selected.
Mode
Speaker
Setup
Band Output
Internal
Speaker
External
SP1
External
SP2
MODE 1
None
A, B
–
–
SP1 only
x
A, B
–
SP2 only
A
–
B
SP1, SP2
x
A
B
MODE 2
None
A, B
–
–
SP1 only
x
A, B
–
SP2 only
B
–
A
SP1, SP2
x
B
A
PROGRAMMABLE VFO
If you always check frequencies within a certain range,
you can set upper and lower limits for frequencies that are
selectable. For example, if you select 144 MHz for the
lower limit and 145 MHz for the upper limit, the tunable
range will be from 144.000 MHz to 145.995 MHz.
1
Select your desired VFO frequency.
2
Enter Menu mode and access Menu 100.
(Example: E type)
3
Press
the
Tuning
control.
• The lower frequency limit blinks.
4
Rotate
the
Tuning
control to select your desired lower
frequency limit, then press the
Tuning
control to set
the selected value.
• The upper frequency limit blinks.
5
Rotate
the
Tuning
control to select your desired upper
frequency limit, then press the
Tuning
control to set
the selected value.
6
Press
[ESC]
to exit Menu mode.
Note:
You cannot program the 100 kHz and subsequent digits. The
exact 100 kHz and subsequent digits of the upper limit depend on the
frequency step size you are using.