Kenwood TKR-750, Programming Reference Manual

Page: 24 / 83

6 EDIT MENU
19 Field Programming Reference (FPRG) Version: 1.01
6.1.8 Power
It can configure the Transmission Power for each
channel. Select “High” or “Low” from the dropdown list.
It is possible to configure the Transmission Power only
when the Transmission Frequency is configured.
(Refer
to 6.1.2 Transmission Frequency.)
6.1.9 Operation Mode
It can configure the Operation Mode for each channel.
Select the mode from Repeat, Simplex, and Duplex from
the dropdown list.
Note:
!
When the reception frequency is same as the transmission
frequency, the Operation Mode is fixed to Simplex mode, so that
you cannot select “Repeat” or “Duplex”.
!
You cannot enable the “Scan Add” when “Repeat” is selected
since the channel has a fixed frequency pair.
(Refer to 6.1.10
Scan Add.)
6.1.10 Scan Add
You can select the channel to be scanned. Select “Yes” or
“No” from the dropdown list.
Note: You cannot enable the Scan Add function when selecting
“Repeat” in the “Operation Mode” since the channel is fixed
to operate the repeater mode.
(Refer to 6.1.9 Operation
Mode.)
6.1.11 CW ID
It can select the repeater to send the CW ID. Select “Yes”
or “No” from the dropdown list.
Note:
!
You cannot send a CW ID while scanning or Scan pauses.
!
When “CW ID On” or “CW Message On” is enabled while
sending the CW ID, the TKR-750/850/751/851 stops sending the
current CW ID and sends the new CW ID instead.
6.1.12 Channel Edit Button
Click “Channel Edit” to view the “Channel Edit” window.
(Refer to 6.2 Channel Edit Window.)
Note: You can open the “Channel Edit” window with one of the
following options.
• Press [F11].
• Double-click the channel number.
6.1.13 Channel Copy ([Shift] + [F3])
It can copy a configured channel data to the other
channel.
Follow the procedures given below to copy a channel.
1. Select the channel to copy.
You can select the channel by clicking the channel
number.
2. Press [Shift] and [F3] at the same time.
The “Channel Copy” window appears.
Figure 6-2 Channel Copy window
3. Select a channel to be copied.
You can select the channel with the spin buttons. You
can also directly enter the channel number.
4. Click “Copy”.
The configuration data is copied to the desired
channel.
Note: You can copy the configuration data only when the
source channel has the configuration data.
Range High, Low
Default High
Range Repeat, Simplex, Duplex
Default
When the transmission frequency is not same as
the reception frequency: Repeat
When the transmission frequency is same as the
reception frequency: Simplex
Range Yes, No
Default No
Range Yes, No
Default No