REPEATER OPERATION
Note: Please consult your dealer for programming the repeater.
When power is applied to the unit, the Power indicator
lights green.
Turn the VOLUME control clockwise until a click sounds,
to unmute the volume. Rotate to adjust the volume. Turn
the VOLUME control counterclockwise fully to mute the
volume.
The BUSY indicator lights green while receiving a signal
and the TX indicator lights red while transmitting.
q
q
q
q
q
Speaker
w
w
w
w
w
CH/STATUS Display
Two, 7-segment digits display the channel number
or status.
e
e
e
e
e
VOLUME control
Turn clockwise until a click sounds, to unmute the
volume. Rotate to adjust the volume. Turn
counterclockwise fully to mute the volume.
r
r
r
r
r
Power switch
t
t
t
t
t
Power indicator
Lights green when power is applied from the DC
13.6V jack (DC 13.2V jack on E type versions).
Lights red when power is applied from the BACK
UP battery terminal.
y
y
y
y
y
MIC jack
Connect a microphone to this 8-pin modular jack.
u
u
u
u
u
Programmable Function keys
Press these keys to activate their programmable
functions.
i
i
i
i
i
BUSY indicator
Lights green while a signal is being received.
o
o
o
o
o
TX indicator
Lights red while transmitting.
■
Rear Panel
q
q
q
q
q
TX OUT jack
Connect a TX antenna or a duplexer to this
receptacle.
w
w
w
w
w
CONTROL I/O jack
Connect an external programming device or
repeater controller to this DB-25 interface.
e
e
e
e
e
FUSE
Insert 15 A blade fuses into these fuse holders.
r
r
r
r
r
RX IN jack
Connect a RX antenna or a duplexer to this BNC
receptacle.
t
t
t
t
t
DC 13.6V
(K type)
/ DC 13.2V
(E type)
jack
Connect a 13.6 V (K type) or 13.2 V (E type) DC
power supply to this jack.
y
y
y
y
y
BACKUP battery terminal
u
u
u
u
u
TEST/SPKR jack
Test input/output jack. Connect an external
speaker to this jack.
TRANSCEIVER OPERATION
■
Receive
Adjust the volume to your desired level. You may need
to readjust the volume when you receive a message
from your dispatcher or another member in your fleet.
•
The BUSY indicator lights green while a signal is
being received.
■
Transmit
1 Listen to the channel before transmitting, to make
sure it is not being used.
2 Press the microphone PTT switch, then speak in
your normal speaking voice.
•
FCC regulations require that you identify the
station you are calling as well as your own
station (your assigned call sign).
•
The TX indicator lights red while transmitting.
3 When you finish speaking, release the PTT switch.
CONTROLS AND FUNCTIONS
■
Front Panel
q
q
q
q
q
w
w
w
w
w
r
r
r
r
r t
t
t
t
t
y
y
y
y
y
u
u
u
u
u
i
i
i
i
i
o
o
o
o
o
e
e
e
e
e
q
q
q
q
q w
w
w
w
w
r
r
r
r
r
t
t
t
t
t
y
y
y
y
y
u
u
u
u
u
e
e
e
e
e
* The K type model is
shown in this diagram.
