8
TK-7102
REALIGNMENT
3-4. Programming Software Description
The KPG-70D programming disk is supplied in 3-1/2" disk
format. The software on this disk allows a user to program
TK-7102 radio via a programming interface cable (KPG-46).
3-5. Programming With IBM PC
If data is transferred to the transceiver from an IBM PC
with the KPG-70D, the destination data (basic radio informa-
tion) for each set can be modified.
4. Clone Mode
Programming data can be transferred from one radio to
another by connecting them via their modular microphone
jacks. The operation is as follows (the transmit radio is the
master and the receive radio is the slave).
NOTE:
Clone mode should enabled.
1. Turn the master TK-7102 power ON with the [1] key held
down. The TK-7102 [ ] LED is turned on.
2. Power on the slave TK-7102.
3. Connect the cloning cable (No. E30-3382-05) to the
modular microphone jacks on the master and slave.
4. Press the [ ] key on the master TK-7102 transceiver. The
data of the master is sent to the slave. While the master
is sending data, [TX] LED blinked. While the slave is re-
ceiving the data, 4 LEDs, [MON] LED, [ ] LED are turned
on and [BUSY] LED blinked. When cloning of data is com-
pleted, the master [TX] LED turned off, and the slave au-
tomatically operates in the User mode. The slave can
then be operated by the same program as the master.
5. The other slave can be continuously cloned. Carry out
the operation in step 2 to 4.
3-3. KPG-46 Description
(PC programming interface cable : Option)
The KPG-46 is required to interface the TK-7102 to the
computer. It has a circuit in its D-subconnector (25-pin) case
that converts the RS-232C logic level to the TTL level.
The KPG-46 connects the modular microphone jack of
the TK-7102 to the computers RS-232C serial port.
KPG-46
IBM-PC
KPG-70D
Fig. 1
Adding the data password.
If the data password is set in the optional feature menu,
you must enter the password (Master transceiver) to acti-
vate a clone mode.
you can use 1, 2, 3, and 4 to configure the password. The
maximum length of the password is 10 digits.
1. [1]+Power ON.
2. [1]~[4] LED, and MON LED are turned ON.
3. Enter the password using [1]~[4] keys.
4. Press [MON] key.
5. If the password matches, the transceiver enters a clone
mode. Otherwise, transceiver beeps and returns to the
password input mode.
Cloning cable
(E30-3382-05)
Fig. 2
TK-7102
