TK-3207
11
3. Attaching the antenna receptacle to the
chassis.
Screw the antenna receptacle to the chassis in the order
shown in the drawing so that the antenna receptacle comes
to the center of the case hole.
4. The nuts of the volume knob and channel
knob
Note that the shapes, colors and heights of nuts of the
volume knob and channel knob are different from one
another. (The nut of volume knob is silver, and the nut of
channel knob is gold)
Use the following jig when removing the nuts of the
volume knob and channel knob.
●
Jig (Part No. : W05-1012-00)
Volume Knob
(Silver)
音量旋钮
（银色）
Channel Knob
(Gold)
信道旋钮
（金色）
3. 把天线插座 (Antenna receptacle) 安装到机架
为了能把天线插座安装到机芯孔的中心，在将天线插座安装
到机架时，请按照图示的顺序固定螺丝。
4. 关于音量旋钮和信道旋钮的螺母
音量旋钮和信道旋钮的螺母形状不同，颜色高度也不同，因
此请注意。
（音量旋钮螺母为银色，信道旋钮的螺母为金色）
另外，拆卸音量旋钮和信道旋钮的螺母时，请使用下列夹具。
●
夹具 (零件号∶W05-1012-00)
DISASSEMBLY FOR REPAIR /
维修拆卸
Tighten this screw first.
首先拧紧此螺丝
Tighten this screw second.
然后再拧紧此螺丝
5. Screw sequence for mounting the TX-RX unit
to the chassis.
Attach the TX-RX unit to the chassis using the screws in
the order shown in the drawing below.
TX-RX UNIT
Component side view
_
11
_
3
_
4
_
2
_
7
_
8
_
9
_
1
_
6
_
5
_
10
5. 安装 TX-RX 单元到机架上的螺钉顺序
利用下图所示的螺钉顺序安装 TX-RX 单元到机架上。
