KENWOOD CORPORATION
FCC ID: ALH36423120
FCC ID: ALH36423130
IC:
282D-36423130
Installing/ Removing the Optional Battery Pack
PREPARATION
The battery pack is not charged at the factory; charge it before use.
CAUTION:
**
DO NOT RECHARGE THE BATTERY PACK IF IT IS ALREADY FULLY CHARGED. DOING SO MAY CAUSE
THE LIFE OF THE BATTERY PACK TO SHORTEN OR THE BATTERY PACK MAY BE DAMAGED.
**
AFTER RECHARGING THE BATTERY PACK, DISCONNECT IT FROM THE CHARGER. IF THE CHARGER
POWER IS RESET (TURNED ON AFTER BEING TURNED OFF), RECHARGING WILL START AGAIN AND THE
BATTERY PACK WILL BECOME OVERCHARGED.
**
DO NOT SHORT THE BATTERY TERMINALS OR DISPOSE OF THE BATTERY BY FIRE.
**
NEVER ATTEMPT TO REMOVE THE CASING FROM THE BATTERY PACK.
1
Match the guides of the battery pack with the corresponding grooves on the upper rear of the transceiver, then firmly
press the battery pack t
2
Flip the safety catch into place to prevent accidentally pressing the release latch and removing the battery.
3
To remove the battery pack, lift the safety catch, press the release latch,then pull the battery pack away from the
transceiver.
