TK-2207
8
DISASSEMBLY FOR REPAIR /
维修拆卸
■
Removing the battery release lever from the case
assembly.
1. Press the upper part of the lever toward the inside of the
case assembly. One side of the shaft will be removed
z
.
2. Lift and remove the battery release lever from the case
assembly
x
.
■
Attaching the battery release lever to the case
assembly.
1. Insert one side of the shaft into the hole at the lever fitting
section on the case assembly
z
.
Caution :
The thin spring (G01-4543-04) should be positioned
above the two tabs of the lever.
2. Tilt the battery release lever slightly forward
x
, so that the
thick spring (G01-4542-04) is positioned below the case
surface.
3. With the thick spring positioned below the case surface,
attach the other side of the shaft to the case assembly by
pressing the battery release lever
c
until it snaps into place
v
.
Caution :
Be careful not to tilt the battery release lever too
forward.
If the battery release lever is pushed in this state
where the two tabs come below the case surface,
there is a possibility of damaging the two tabs.
2
1
1
3
2
4
A thin spring /
细弹簧
Shaft /
轴
Two tabs /
2个突起的上侧
A thick spring /
粗弹簧
■
从机壳拆卸电池分离拨杆
1. 向机壳的内侧按压拨杆上部之后，就可以卸下轴的一侧
z
。
2. 拿起电池分离拨杆
x
，就可以从机壳上拆卸下来。
■
把电池分离拨杆安装到机壳
1. 把轴的一侧插入到机壳的拨杆安装部的孔里
z
。
注意∶
细弹簧(G01-4543-04)的横杆部分应安装到拨杆的 2 个
突起的上侧。
2. 轻轻地前推电池分离杆倾斜到
x
，这样粗弹簧(G01-4542-04)
被定位在机壳下面。
3. 随着粗弹簧定位到机壳下面，通过按电池分离杆
c
直到它
嵌到位置
v
轴的另一侧接触机壳组件。
注意∶
注意不要把电池分离杆倾斜得太靠前。
如果电池分离杆被推到机壳下面的 2 个卡头的位置，就
有可能损坏此 2 个卡头。
