Kenwood TK-2000, Service Manual

Page: 3 / 40

TK-2000
3
SYSTEM SET-UP
REALIGNMENT
1. Modes
Mode Function
User mode For normal use.
PC mode
Used for communication between the trans-
ceiver and PC.
Data programming
mode Used to read and write frequency data and
other features to and from the transceiver.
PC test mode
Used to check the transceiver using the PC.
This feature is included in the FPU.
Clone mode
Used to transfer programming data from
one transceiver to another.
2. How to Enter Each Mode
Mode Operation
User mode Power ON
PC mode Received commands from PC
Clone mode [PTT]+[Side]+Power ON (Two seconds)
3. PC Mode
3-1. Preface
The transceiver is programmed by using a personal com-
puter, a programming interface (KPG-22A/22U) and FPU
programming software (KPG-137D : ver.2.20 or later).
The programming software can be used with a PC. Fig-
ure 1 shows the setup of a PC for programming.
3-2. Connection Procedure
1. Connect the transceiver to the personal computer with
the interface cable.
Note:
• You must install the KPG-22 driver in the computer to use
the USB programming interface cable (KPG-22U).
Choose the type of transceiver
Transceiver programming
Delivery
Are you using the speaker microphone?
A personal computer, programming interface (KPG-22A/22U),
and FPU (programming software) are required for programming.
(The frequency, TX power HI/LOW, and signaling data are
programmed for the transceiver.)
YES
NO
KMC-21 or KMC-45
Speaker microphone
(Option)
Are you using the optional antenna?
YES
NO
TX/RX 136~174 5.0W TK-2000 K,M
Frequency range (MHz) RF power Type
Merchandise received
Optional antenna
KRA-22 or KRA-26
User mode
Data programming mode
PC test mode
PC tuning mode
PC mode
Clone mode