ENGLISH
7
EN
Specifications
Controls and indicators
1
POWER switch
Switches the power ON and OFF.
2
POWER ON indicator
3
VOLUME control knob
Adjusts the volume level of the output of the Subwoofer.
Rotating the knob clockwise increases the volume level,
and rotating the knob counterclockwise decreases the vol-
ume level.
4
LINE INPUT jack (RCA-type pin-plug)
This jack is used to connect the subwoofer Pre-Out jack of
the amplifier.
5
Power cord
Connect to AC outlet.
Caution concerning operation
An excessive input level to the Subwoofer may impair the sound
quality or damage the unit. Careful attention should therefore
be paid to the following precautions.
Caution: Read this page carefully to ensure safe operation.
Notes:
1. Kenwood follows a policy of continuous advancements in development. For this reason, specifications may be changed without
notice.
2. Full performance may not be exhibited in extremely cold locations (below 0 deg. C).
[Speaker]
Enclosure ..........................
Bass-Reflex, Floor Standing Type
Speaker Units ...........................
160 mm (6-1/2 ") Cone type
Nominal Impedance .......................................................
6
Ω
Dimensions
Width ................................................... : 210 mm (8-1/4 ")
Height ................................................ : 400 mm (15-3/4 ")
Depth .............................................. : 373mm (14-11/16 ")
Net Weight ......................................................
10 kg (22.1 lb)
NOTE: THE GRILLE CANNOT BE REMOVED.
Notes:
1. Do not increase the output of the amplifier to a high level
while the low-frequency level is enhanced by the amplifier’s
tone control or loudness control.
2. When operating the amplifier switches or when placing the
stylus on an analog record, set the amplifier volume to its
minimum level.
1
3
2
4
5
Type ......................
Subwoofer system with built-in amplifier
[Amplifier]
Dynamic Power ................................................
100 W (6
Ω
)
(For U.S.A. and Canada)
Rated Output Power (FTC)
75 W RMS, at 6
Ω
100 Hz, with no more than 0.7 % T.H.D.
Input Sensitivity & Input Impedance ........
300 mV (37 k
Ω
)
Rated Power Consumption ........................................
70 W
Frequency Response ...................................
25 Hz ~ 160 Hz
(For other countries)
Rated Output Power .....................
75 W RMS (100 Hz,6
Ω
)
Input Sensitivity & Input Impedance ........
300 mV (37 k
Ω
)
Rated Power Consumption ........................................
70 W
Frequency Response ...................................
25 Hz ~ 160 Hz
