5
EN
7
Mono (bridged, or BTL) configuration
In this configuration, the MX-5000’s two individual channels op-
erate together to drive a single speaker (such as a subwoofer) in
mono. This allows the amplifier to deliver more than double the
power of one of its channels to the speaker.
1
Make sure that the MX-5000’s power cord is unplugged
from the wall outlet before making any connections.
2
According to the speakers to be used, set the speaker
impedance selector switch as follows:
•
For 6-16
Ω
speakers: Set the 2
Ω
(STEREO)/6
Ω
OVER
switch to 6
Ω
OVER and 6
Ω
OVER/2
Ω
switch to 2
Ω
.
3
Connect the amplifier as shown in the diagram.
• Make sure to connect the audio input cable to the
MONO/
BTL
input.
Note:
Since bridged operation produces
enough output power to pose a small
risk of electrical shock from the
speaker terminals, please attach the
terminal cover as shown in the diagram
below:
Now you can plug the power cord of this unit into the AC outlet!
CAUTION:
Before reconnecting a speaker cord or switching a selector switch, turn OFF the power and unplug the power cord to
avoid malfunctions or damage to the unit.
CLIP
INDICATOR
CD 2 / TAPE 2
MONITOR
SURROUND
BACK
96kfs
DISCRETE 6.1
MATRIX 6.1
NEO : 6
PRO LOGIC
DTS-ES
Mount the supplied speaker
terminal cover using the two
screws that are attached to
the unit.
VR-5900
When a monaural
pre-out signal is to
be connected, be
sure to connect it
to the MONO/BTL
terminal.
Audio cord (not supplied)
Stereo mini-plug cord (supplied)
To wall AC outlet
Subwoofers
(6
Ω
-16
Ω
)
For 12 V RELAY CONTROL, see page 7.
