10 -
English
Installation
Installation location and cleaning
Select for installation a location where the stand can be placed
completely horizontal or where the front edge of the support
(petal-shaped part) can be attached horizontally as shown in
Figure
A
.
Do not install in locations where the entire support is at a
diagonal such as in Figure
B
or where the monitor unit is
facing down such as in Figure
C
.
Thoroughly wipe away and dust or grease from the installation
location using a cloth which has been soaked in a neutral
cleaning agent and wrung out. Attach the stand after allowing
the installation location to dry.
2
CAUTION
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
;;;;;;;;
A
B
C
Bend the stand support to conform to the shape of the
installation location.
Adjust the shape of the support so that there is no rattling
or gap when the stand is placed on the support.
Peel off the protective strip from the double-sided tape on
the bottom of the stand and securely attach the stand.
• Do not attach the double-sided tape more than once or
touch the adhesive with your fingers as this will weaken
its adhesive strength.
• If the temperature of the surface of the installation
location is low, warm it up using a heater or other means
before attaching the stand. Low temperature may
weaken the adhesive strength of the tape.
• The supplied stand is specially intended for this product.
Do not use it with another monitor.
Secure the stand using the supplied tapping screw
(Accessory
H
).
After attaching the stand, allow it to sit undisturbed for 24
hours.
Take care not to apply any force to the stand during this
time.
Fully loosen the installation screws, align the slit on the
rear of the unit with the installation shoe and slide the
monitor unit onto the stand.
Adjust the height, horizontal angle and vertical angle of the
monitor and securely tighten the installation screws.
You can also adjust the monitor unit's forward position by
loosening the angle adjustment knobs and adjusting the
angle of the monitor unit's installation stand.
8
7
6
5
4
2
CAUTION
3
2
1
Installation for Monitor Unit
Accessory
E
Accessory
H
Protective strip
Tighten
Loosen
Installation surface
Tighten
Loosen
LZ-7500(W)_EFG_01 02.2.15 10:14 AM Page 10
