KVT-M700
12
ADJUSTMENT
Unit Adjustment
Item
Adjustment Method, Adjustment Value
Condition
1. Adjustment of
First, reset by pressing both VOLDW and SRC keys at the same time and boot up the
· Adjustment pin (with
Touch Panel
system in Test Mode.
smaller tips of about
Display the Touch Adjustment Screen with the SRC key of TV remote controller, press
0.2mm in diameter.)
center section of the "Cross-font" using adjustment stick.
· Test Mode
(Upper left
upper r ight
lower left.)
Note 1: When conducting the adjustment for the first time, the display position of the
cross-cursor may be a little off, but the adjustment should be conducted by using the
center position of the font.
Note 2: If adjustment becomes impossible as a result of having input incorrect values,
clear the E2PROM first and then conduct the adjustment. This can be done by resetting
while pressing VOLDW and OPEN/CLOSE keys. When this is done, the machine also
loses the mechanical positions. Therefore, this must also be adjusted again.
2. Mechanism Tilt
1. How to remove the monitor.
Adjustment
2. Monitor Installation Method (Tilt-side sensor value setting method)
Impress 8V voltage on the tilt-behavior side motor
terminal and let the motor full-tilt down.
Install a small screw (N09-6010-08) on the side of the
slider assembly (D10-4679-08.)
Impress 8V voltage on the tilt-side motor terminal and
let the motor rotate toward tilt-up direction.
Make the gear 19 (D13-2201-08) biting softer.
Remove the mounting hardware assy L (J21-9780-14)
and the mounting hardware assy R (J21-9782-14),
and remove the motor.
With the monitor back plate surface in 174
±
2
˚
˚
174
±
2
˚
˚
position to the mechanical
unit top surface, install the monitor and attach the mounting hardware
assy L (J21-9780-14) and the mounting hardware assy R (J21-9782-14).
Mechanical Unit Surface
Monitor Back Plate Surface
Monitor
Impress 8V-voltage on the tilt-behavior side motor terminal and
let the monitor full-tilt down.
Impress 5.0V to tilt-side sensor input and turn the tilt gear so that
the output of the tilt-sensor is 0.2
±
0.1V.
Remove the small screw (N09-6010-08) of the slider assy (D10-4679-08)
and impress 8V-voltage on the motor terminal of the tilt behavior side.
Then, let the motor tilt-up to full and then tilt-down to full.
End
OK
NG
Impress 5V-voltage on the tilt-side sensor input and confirm that
the output of the tilt-sensor is 0.2
±
0.1V.
