EN
7
ENGLISH
Horizontally
1
Screw two screws into the walls 150 mm
(5-7/8 inches) apart, making sure that screws
are horizontally level. Screw each screw only
part way in, so that the screw projects 8 to
10 mm (5/16 to 3/8 inches) outward from the
wall surface.
2
Hang the speaker by fitting the two mount
holes (at the rear of the speaker) over the
extending part of the screw. Confirm that the
speaker is held firmly and securely in place.
Mounting methods
(Surround speaker)
The speaker can be installed on the SR-8000 stand
optionally available from Kenwood.
And any commercially available speaker mount or
bracket can also be used (provided that the speaker
can be fixed using an M5 screw with a pitch of 60 mm
and effective thread length of 10 to 13 mm (3/8 to 1/2
inches)). For details, read the instruction manual for
the speaker mount or bracket.
Effective thread
length
M5 screw
Using speakers on the wall
(Surround speaker, Center speaker)
The speakers include mount holes for wall mounting.
You can hang the surround speakers on the wall
vertically, and the center speaker horizontally.
Precautions:
Please observe the following precautions when
mounting speakers onto the wall.
• Be sure that the wall you are using is strong enough to
support the full weight of the speaker (approx. center
speaker : 0.7 kg [1.5 lb], surround speaker : 0.5 kg [1.1
lb]).
• Wall screws must be purchased separately. Be sure to
use screws that are appropriate for the wall you are
using, and that are long enough to provide sufficient
strength.
• If you are uncertain about the wall’s support strength,
the type of screw to use, or any other points regarding
this type of installation, please consult a contractor or
other qualified person before proceeding.
Be sure to follow the procedure given here when carrying
out installation. Kenwood can assume no liability for
injury or damage that may occur if a speaker setup
falls from the wall as a result of incorrect installation or
insufficient support strength.
Vertically
1
Screw a single screw into the wall at the
desired location. Screw it only part way in,
so that the screw projects 8 to 10 mm (5/16
to 3/8 inches) outward from the wall surface.
2
Hang the speaker by fitting the top mount
hole (at the upper rear of the speaker) over
the extending part of the screw. Confirm
that the speaker is held firmly and securely
in place.
