KMC-41D
3
2. Installing the cable ASSY
1) Pass the connector part of cable ASSY through the hole
of the front case.
2) Move the three lead wires soldered onto the PCB to the
upper corner of the hole.
Three lead wires
Connector part of cable ASSY
Fig. 6
3) Make sure the yellow lead wire side of the connector is in
the inside of the front case.
Yellow lead wire
Fig. 7
4) Push the connector (yellow lead wire side) to the lower
corner of the hole using a pair of tweezers.
Note:
Attach adhesive tape or rubber to the end of the
tweezers so as not to damage the connector of the cable
ASSY.
5) Pass the connector through the hole by pushing the con-
nector (white lead wire side) using a pair of tweezers or
similar tool.
Yellow lead wire
Fig. 8
6) Push the cable ASSY to the inside of the case, then in-
sert the fi xing bracket of the cable ASSY to the hole of
the front case.
7) Fit the holder to the fi xing bracket of the cable ASSY.
Fixing bracket
Holder
Fig. 9
8) Insert the cap in the earphone jack hole of the front case.
9) Apply the bond (*1) at the position shown in the fi gure,
then fi rmly attach the cable ASSY and case.
Note:
Take care not to apply the bond to the waterproof-
ing line of the front case.
*1: Use the following bond :
• Manufacture name: Shin-Etsu Chemical Co., Ltd.
•
Bond name: Shin-Etsu silicone One-component RTV
silicone rubbers Alcohol type KE-4898-T
Bond
Fig. 10
DISASSEMBLY FOR REPAIR