11
installation
7. Make sure your plumbing is suitable for
use with the dishwasher. If in doubt contact
a qualified plumber. This unit MUST BE
connected to COLD WATER MAINS using
the new water inlet hose. OLD HOSE
SETS MUST NOT BE RE-USED. The
water pressure from the water mains
needs to be at a minimum of 0.04 MPa and
a maximum of 1.00MPa.
• Connect one end of the safety water
supply hose to your dishwasher, and
then connect the other end of the hose
to your water mains. Please ensure the
black rubber seal is in place.
• After connecting the hose, turn on your
water mains and check for leaks.
• Connect the dishwasher to the mains
socket.
• Do not bend your drain hose.
water mains
safety water supply hose
Y-Adaptor
(not included)
Connect to
another
appliance
if required.
6. Position the dishwasher next to a water
tap and a drain. Ensure the water inlet and
drain hoses are not kinked or squashed.
The unit must not stand on the mains
cable.
Power
Delay
Start
1/2 Load
3in1 In
tensive N
ormal
Eco
Rinse
Glass
Rapid
You may use a Y-adaptor (not
included) for an additional water
feed for another appliance, for
example a washing machine. This
is only applicable for cold water
mains. A Y-adaptor is available
from most DIY stores.
Summary of Contents for KDW45S13
Page 1: ...Slimline Dishwasher KDW45S13 installation instructions manual ...
Page 2: ......
Page 35: ......