GB-4
starting a wash cycle
Please follow the steps below to start a wash cycle.
Ensure the unit is connected to the mains power and the water sup-
ply is on (water pressure between 0.04MPa and 1.00MPa).
Open the door. Pull out the lower and upper baskets, load the dishes
and push the baskets back. It is recommended that the lower basket
is loaded first, and then the upper basket.
Pour in the detergent or place the detergent tablet in the detergent
compartment and close firmly afterwards.
Press the ON/OFF button.
Select the wash cycle programme based on the loading and soil re-
quirements. Please refer to the “Wash Cycle Table” (page 13).
The indicator light of the selected programme will illuminate.
Close the dishwasher door. A click sound should be heard when the-
door is closed correctly. Do not slam the door.
The washing cycle will begin shortly.
NOTE
: If you open the dishwasher door during the washing cycle and
then close it, the dishwasher will continue the current washing pro-
gramme after 10 seconds. However, if the door is not closed correctly
after 1 minute, the dishwasher will make an audible sound at 1 minute
intervals.
changing a programme
To change the programme if the washing cycle has already started,
follow the steps below.
Open the door slightly to check if the unit has dispensed the deter-
gent or detergent tablet. This will depend on how long the washing
cycle was running for.
If the detergent dispenser lid is opened, we suggest you allow the
wash cycle to finish.
If the detergent dispenser lid is still closed, press and hold down the
programme button for 3 seconds to cancel the programme. You can
then press the required new programme button and close the dish-
washer door. The unit will start the new washing cycle shortly.
1.
.
3.
4.
5.
6.
7.
8.
1.
.
3.
