KDC-MP819/X659/Z838
9
• When the model is equipped the CD mechanism
assembly adapted for MP3 or MP3/WMA disc, the
mechanism name and version number are displayed
during the CD source selecting.
• When the disc media is CD, A short press of the Preset 1
key jumps to the track number 28.
7. Audio-related specifications
• A short press of the Q key initiates the audio adjustment
mode.
• Pressing the
∗
key on the remote initiates the audio
adjustment mode.
• Fader is selected to the initial item.
• Continuous holding of a remote control key is inhibited.
• Bass, Middle and Treble are adjusted in 3 steps of Min /
Center / Max with the Track Up/Down keys.
• Balance is adjusted in 3 steps of Left Max / Center / Right
Max with the Track Up/Down keys.
• Fader is adjusted in 3 steps of Rear Max / Center / Front
Max with the Track Up/Down keys.
• HPF is adjusted in 2 steps of Through / 220Hz with the
Track Up/Down keys.
• LPF is adjusted in 2 steps of Through / 120Hz with the
Track Up/Down keys.
• Bass f, Bass Q, Bass EXT, Middle f, Middle Q and Treble
f are not dealt with by the audio adjust.
8. Menu-related specifications
• Pressing the DNPP/SBF key on the remote initiates the
Menu mode.
• Continuous holding of a remote control key is inhibited.
• In the case of the CD receiver model, A short press of
the PLAY/PAUSE key initiates the Menu mode.
9. Backup current measurement
When the unit is reset while ACC is OFF (i.e. by turning
Backup ON), the MUTE terminal goes OFF in 2 seconds in
place of 15 second. (The CD mechanism is not activated at
this time.)
TEST MODE
1. How to enter the test mode
While pressing and holding the Preset 1 and Preset 3 keys,
reset the unit.
2. How to exit from the test mode
Reset the unit, ACC OFF, power OFF and Panel detached.
(Note) The test mode cannot be terminated by momentary
power down.
3. Initial status in the test mode
• Sources
: ALL OFF
• Display
: All segments are lit.
• Volume
: –10 dB (displayed as "30")
• Loudness
: OFF
• CRSC
: OFF regardless of the presence of
switching function.
• SYSTEM Q
: Flat
• BEEP
: When pressing any keys, the buzzer
generates a beep at any time.
4. Special display in Tuner mode
When any of the following messages is displayed in Tuner
mode, the F/E may be abnormal.
• "TNE2P NG": The EEPROM is set to the default (unstable
values) because the F/E was shipped without passing
through the adjustment process, etc.
• "TNCON NG": Communication with the F/E is not
possible.
5. Forced switching of K3I
Each press of the Preset 6 key in Tuner mode should switch
K3I from AUTO
→
Forced Wide
→
Forced Middle
→
Forced
Narrow
→
AUTO.
The initial status is AUTO and the display shows these
modes as follows.
• AUTO
6. Test mode specifications of the CD receiver
• Forced ejection is inhibited in the reset start operation.
When the unit is reset while a CD is loaded in it, the CD
is not recognized by resetting.
• Each press of the Track Up key jumps to the following
track numbers:
No. 9
→
No. 15
→
No. 10
→
No. 11
→
No. 12
→
No. 13
→
No. 14
→
No. 9 (The cycle restarts from here.)
• Each press of the Track Down key jumps to the previous
track number to the track being played.
• When the number of total trucks of the MP3 disc or the
WMA disc is less than 9, 1st truck is played.
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
