KDC-CX87/CPS87
8
ADJUSTMENT
L.P.S. initial position adjustment procedure
1. Connect the changer to the H/U.
2. While holding the magazine eject button of
the changer, press the reset button of the
H/U.
3. After about 3 seconds, release the
magazine eject button.
4. Press the SRC button of the H/U to enter
the CD-CH mode, and the H/U’s display
section indicates “E-88”.
5. Move the mechanism deck to around the 1st
stage by pressing the DISC- or DISC+
button.
6. Insert the adjustment tool (W05-0635-00)
into the tool hole on the changer
mechanism.
7. Then press the DISC+ button to move the
mechanism deck until the mechanism’s
slider hits the adjustment tool.
8. When the motor locks (stops), press the
REPEAT key of the H/U.
When the REPEAT key is pressed, the mechanism moves automatically to the 1st stage and the initial position
adjustment completes. (The data is written in the EEPROM at this time.)
W05-0635-00
Summary of Contents for KDC-CPS89
Page 21: ...KDC CX87 CPS87 25 MEMO ...
